Servos moving randomly and trying to reset?
My two boards are connected (tested via the boot button), but when sending input via the capacitive touch, about 50% of the time, the servos will just moving from 0⁰ to 180⁰ and back again, over and over, until they decide to stop, and then accept no input for about 20 seconds, and then reconnect (three blue flashes). Then, the device which I was using won't accept any input, and i have to send a message from the other device.
When they do work (touch steps the motor about 30⁰) when it gets to the 0⁰ position, the servo is trying to go further (can hear the motor whining/attempting to go further).
I've flashed the boards a couple of times - does it sound like there's an issue? Anyone with any suggestions?
thanks!
Is this a good question?